R30935,00 incl.Vat
In Stock
nationwide
find a branch
| Attribute 1 | Dimensions (L X W X H) : 680x350x1030 |
|---|---|
| Attribute 2 | Weight: 60 Kg |
| Attribute 3 | Foot Size (L X W) (mm): 300 X 250 |
| Attribute 4 | Stroke (mm): 30 – 70 |
| Attribute 5 | Impact Force kN(kgf): 9.8Kn (1000Kgf) |
| Attribute 6 | Fuel Tank Capacity (L): 2 |
| Attribute 7 | Power Source: Honda GX100 |
Compacts many materials in medium and deep layers including trenches, foundations, backfills etc.
Starting:
Turn Petrol on
Accelerator lever should be in idle position before starting
Open choke (Butterfly closes the air flow)
Pull the recoil until the machine starts
Close the choke (Butterfly opens the air flow)
Leave machine to warm up before accelerating
Running:
Ensure the thickness of non-compacted material is approximately 300mm
3 to 4 passes of the machine advancing at its normal pace will be optimum
Do not over compact or run the machine over a hard surface
Always run the machine at full power
Don’t force the machine only guide it
Stopping:
Before shutting down make sure the machine is running on a safe flat surface
Make sure the machine is in your control
Reduce the throttle fully so that the engine can fully cut out
Turn off the petrol
Refuelling:
Allow the machine to cool down before refuelling
Ensure petrol switch is off before refuelling.
Machine may not be running whilst refuelling.
Do not smoke or use a cell phone whilst refuelling.
Remove fuel cap and place in a clean dry area within reach of the machine.
Pour the fuel into the tank.
Regular use of hand-arm equipment may cause injury and disability.
This equipment creates dust. Wear a suitable mask.
Eye protection must be worn while using this equipment.
Hand protection must be worn while using this equipment.
Industrial footware with steel toecaps whould be worn while using this equipment.
Ear protection must be worn while using this equipment.© 2025 TURNER MORRIS | E&EO
